Restoring VMware QuickSpin Backups

To restore a VMware QuickSpin backup, perform the following steps.

1. Navigate to the Computer page. See Navigating to the Computer Page for instructions.
   The Computer page is displayed.

   Open

   

    

2. Click the Restore tab.
   The Restore Selections page is displayed.

   Open

   

3. Click VMware QuickSpin.
   The Select page is displayed.

   Open

   

4. In the Current Selection pane, select the VMs and revisions to be restored.
   Clicking the arrow at the right of the VM displays more revisions of the VM.
   Your selection is displayed in the right pane.

   Open

   

5. Click the remove icon to remove any selections or clear the item check box.

   Open

   

6. Click Next.
   The Recovery Type page is displayed.

   Open

   

7. Select a Recovery type radio button.

   If you select Sandboxed Test Recovery (default option):

   • The source/production VMs are not shut down.

   • The recovery VMs selected are started on their own separate VLAN to avoid conflicts with the production VMs.

   • Backups to the recovery VMs do not continue if the recovery VMs are powered on.

   If you select Production Recovery:

   • The source/production VMs are shut down.

   • The recovery VMs selected are started on the production network. They assume the role of the original production VMs.

   • Backups to the recovery VMs do not continue if the recovery VMs are powered on.

8. Click Next.
   The Summary page is displayed.
   Note: For this example, the Production Recovery option is displayed.

   Open

   

   Notes:

   If necessary, power off non-critical VMs at the destination so enough resources are available to start the recovery VMs.

   If the VMs selected for restore are currently being backed up, the backup of the VMs are canceled to allow the restore to proceed.

9. Verify your selections, and then click the Restore button.
   If you selected Production Recovery at the Destination page, then the following confirmation pop-up is displayed.

   Open

   

   By checking the checkbox and selecting Yes, the currently running Production VM(s) are shut down and replaced by the VMware QuickSpin VMs you have selected to restore.

10. Click the Yes, restore the selected VM(s) check box, and then click Yes.
    If you selected Sandboxed Test Recovery at the Destination page, then the following confirmation pop-up is displayed.
    
    

    Open

    

11. Click Yes.

    The Restore Selections page is displayed with the latest restore.

12. Add the Recovery VMs to an existing backup set or create a new one to ensure that the newly recovered VMs are protected.

13. Remove the original Production VMs from the backup sets to avoid unnecessary errors.