Manually Configuring the Windows Management Framework

Barracuda RMM Onsite Managers query WMI over the WSManagement Protocol. If the WS-Management protocol is not available on a device, Barracuda RMM Onsite Manager reverts to querying WMI over DCOM.

In order to utilize WS-Man, Windows Management Framework (WinRM 2.0) or greater must be installed. Below are the steps required to configure the Windows Management Framework manually on a device.

1. Launch Command Prompt as Administrator.

2. Run the following command and look for the version: 

   PowerShell.exe Get-Host

1. Launch Command Prompt as Administrator.

2. Run the following command and follow the prompts to enable WinRM: winrm quickconfig –q

3. Run the following commands to apply the required configuration changes:

   winrm set winrm/config @{MaxEnvelopeSizekb = "2000"} winrm set winrm/config/client @{TrustedHosts="*"} winrm set winrm/config/client/auth @{Basic="true"} winrm set winrm/config/service @{EnumerationTimeoutms="240000"} winrm set winrm/config/service @{MaxConcurrentOperationsPerUser="1500"} winrm set winrm/config/service @{MaxConnections="50"} winrm set winrm/config/service/auth @{Basic="true"}

1. Launch Command Prompt as Administrator.

2. Run the following command and follow the prompts to enable WinRM: winrm quickconfig –q

3. Run the following commands to apply the required configuration changes:

   winrm set winrm/config @{MaxEnvelopeSizekb = "2000"} winrm set winrm/config/client @{TrustedHosts="*"} winrm set winrm/config/client/auth @{Basic="true"} winrm set winrm/config/service @{EnumerationTimeoutms="240000"} winrm set winrm/config/service @{MaxConcurrentOperationsPerUser="1500"} winrm set winrm/config/service @{MaxConnections="300"} winrm set winrm/config/service/auth @{Basic="true"} winrm set winrm/config/service @{AllowRemoteAccess = "true"}