Integrating Cisco Adaptive Security Appliance (ASA)

Integrating Cisco Adaptive Security Appliance (ASA)

If you are using a physical or virtual sensor, see Integrating a Cisco Adaptive Security Appliance at the bottom of this article.

  • Enable Cisco Adaptive Security Appliance (ASA)

  • Install the XDR Collector

  • Configure the Firewall

  • Open the Port on the XDR Collector Host

Enable the Cisco Adaptive Security Appliance (ASA)
  1. In Barracuda XDR Dashboard, navigate to Integrations Integrations.png.

  2. On the Cisco Adaptive Security Appliance card, click Setup.

    Cisco Adaptive Security Appliance (ASA) integration card
  3. Select the Enable check box.

    Check box enabled
  4. If the default UDP port can't be forwarded because it is already in use, type a different UDP port number.

  5. Click Save.

Install the XDR Collector

When collecting logs from one or more integrated data sources, always set up the XDR Collector on a dedicated host server. Don't use an existing server because the amount of data produced by logs can impact critical infrastructure.

Configure the Firewall

Syslog servers can be defined in the Cisco Adaptive Security Appliance (ASA). Choose Configuration > Device Management > Logging > Syslog Servers.

  1. Click Add a syslog server and enter the following:

    • Specify the interface that the server is associated with.

    • IP Address: The static IP address of the system hosting the XDR Collector.

    • Specify the protocol: UDP

    • UDP port: 9220

  2. Click OK.

You can find more documentation at the following:

Open the Port on the XDR Collector Host

Ensure incoming traffic is allowed on UDP port 9220.

Linux

sudo ufw allow 9220/udp

Windows

netsh advfirewall firewall add rule name="Cisco ASA Firewall Events" dir=in action=allow protocol=UDP localport=9220


Integrating a Cisco Adaptive Security Appliance

For full instructions, see Cisco.

To send Logging Information to a Syslog Server

logging host interface_name ip_address [tcp[/port] | udp[/port]] [format emblem]

logging trap severity_level

logging facility number

A server that runs a syslog application is required in order to send syslog messages to an external host. ASA sends syslog on UDP port 514 by default, but protocol and port can be chosen. If TCP is chosen as the logging protocol, this causes the ASA to send syslogs via a TCP connection to the syslog server. If the server is inaccessible, or the TCP connection to the server cannot be established, the ASA will, by default, block ALL new connections. This behavior can be disabled if you enable logging permit-hostdown. See the configuration guide for more information about the logging permit-hostdown command.

 

The ASA only allows ports ranging from 1025-65535. Use of any other ports will result in the following error: 

ciscoasa(config)# logging host tftp 192.168.1.1 udp/516\

WARNING: interface Ethernet0/1 security level is 0.\

**ERROR: Port '516' is not within the range 1025-65535.**

 


We value your feedback.
If you have questions, suggestions, or feedback on our documentation, contact the Campus Product Documentation team.
For general product inquiries or technical support, please contact the global Barracuda Support team.