Integrating Juniper SRX Firewall

Integrating Juniper SRX Firewall

This setup is for the XDR Collector only. If you are using a physical or virtual sensor, contact your administrator.

To set up Juniper SRX Firewall, do the following procedures, below:

  1. Enable the Juniper SRX integration

  2. Install the XDR Collector

  3. Configure the Firewall

  4. Open port on the XDR Collector Host

Enable Juniper SRX

  1. In Barracuda XDR Dashboard, navigate to Integrations Integrations.png.

  2. On the Juniper SRX card, click Setup.

    Juniper SRX integration card
  3. Select the Enabled check box.

    check box enabled
  4. If the default UDP port can't be forwarded because it is already in use, type a different UDP port number.

  5. Click Save.

Install the XDR Collector

When collecting logs from one or more integrated data sources, always set up the XDR Collector on a dedicated host server. Don't use an existing server because the amount of data produced by logs can impact critical infrastructure.

Configuring the Firewall

  1. To add a Syslog server to the Juniper SRX Firewall, follow the steps in Juniper Firewall Documentation

  2. When entering the necessary information for each syslog server that is added, make sure that the port is pointing to 9206, not to the default port as can be seen in the sample picture below:

Open the Port on the XDR Collector Host

Ensure incoming traffic is allowed on UDP port 9206.

Linux

sudo ufw allow 9206/udp

Windows

netsh advfirewall firewall add rule name="Juniper SRX Collector Firewall Events" dir=in action=allow protocol=UDP localport=9206


We value your feedback.
If you have questions, suggestions, or feedback on our documentation, contact the Campus Product Documentation team.
For general product inquiries or technical support, please contact the global Barracuda Support team.