Integrating WatchGuard

Integrating WatchGuard

To set up WatchGuard, follow the procedures below:

  • Enable WatchGuard

  • Install the XDR Collector

  • Open the Port on the XDR Collector Host

Enable WatchGuard

  1. In Barracuda XDR Dashboard, navigate to Integrations Integrations.png .

  2. On the WatchGuard card, click Setup.

    WatchGuard integration card
  3. Select the Enabled check box

    Check box enabled
  4. If the default UDP port can't be forwarded because it is already in use, type a different UDP port number.

  5. Click Save.

Install the XDR Collector

When collecting logs from one or more integrated data sources, always set up the XDR Collector on a dedicated host server. Don't use an existing server because the amount of data produced by logs can impact critical infrastructure.

Configure the Firewall

  • To add a Syslog server to the WatchGuard Firewall, follow the steps in the Watchguard documentation.

  • When entering the necessary information for each syslog server that is added, make sure that the port is pointing to 9270, not to the default port that is mentioned in the documentation.

Open the Port on the XDR Collector Host

Ensure incoming traffic is allowed on UDP port 9270.

Linux

sudo ufw allow 9270/udp

Windows

netsh advfirewall firewall add rule name="WatchGuard Events" dir=in action=allow protocol=UDP localport=9270


We value your feedback.
If you have questions, suggestions, or feedback on our documentation, contact the Campus Product Documentation team.
For general product inquiries or technical support, please contact the global Barracuda Support team.